Liczymy pasujące modele…
I wanted a case for my new phone, but being a budget option, it's not overly popular. This case is admittedly somewhat thick, but I wanted it to be able to sit flat on flat surfaces, rather than rocking around due to the camera. Printed…
I was commissioned to print this for a friend's cosplay, but since no other model already existed, I needed to model it. Turns out the thing is huge, so I've split it up to fit on a Prusa i3 bed. All parts are held together with m4 screws…
Needed an angle finder, so here we go. Redesigned the tool to actually be usable. Perhaps not as nice looking, but clamps together in the 0 degree direction with a nice snap if you print it right. No extra parts needed, just print in…
Hide those nasty cable runs in this 2 piece cable run. No supports required, fits on most beds, adjustable in length (cut in PrusaSlicer) and usable with screws for a more permanent solution or removable Command strips for a rent-friendly…
I had my cables catching on the top of the acrylic top, causing issues. There were a few bridges on thingiverse but none for the newer FFCP, so here we are. Print standing upright with a brim and it should be golden Print instructions…
Bought a new power supply for my MPMD and wasn't happy with the exposed mains lines, so I designed this to hold it in place without screws and for a little airflow from bottom to top. The power supply I made it for is the Mean Well…
To wszystkie aktualnie dostępne wyniki.
