Liczymy pasujące modele…
There are a lot of endcaps out there for the 2040 extrusion used to construct the Full Bear upgrade to the MK3. I was having a hard time finding an endcap that slid into the end of the extrusion rather than down the front and sides. This…
I have remixed this to add a hole in the bottom. This hole is sized just shy of 7mm so that you can melt a threaded insert in nice and tight. Big thank you to the original upload, this helped with my PiCam security system mounting. I…
There are many like it but this one is mine. It holds stepper motor wires. You will notice it sits about a mil short of flush. I needed to design around some bolt ends for my Einsy case plus I like the look. My name is on the side but I…
I lost the original sensor cover for the Bondtech Mosquito Mk3s upgrade so I fabbed up another one. This will fit the Mosquito upgrade for the Mk3s from Bondtech. I printed with no supports. You do you on that one. This was modeled in…
This is just the main drive belt for the Apier line of single drive pool cleaners. It may work for the dual drive as it appears they have the same sized belt. Print with 4 walls and stagger the seam. If you don't it will fail much sooner…
To wszystkie aktualnie dostępne wyniki.
