Liczymy pasujące modele…
This is a 30.5mm to 20mm FC adapter. The 20mm mounting uses 2mm screws and can be tapped as is. Fits my Xrotor nano stack perfectly! Category: R/C Vehicles
** Added Bottom that will hold a 15mm thick fan. ** Added lid with V1 Engineering logo I increased the size of the hole for the wire entry and shrunk all bolt holes to 2.75mm for direct fit of 3mm hardware. Also created a basic flat top…
Decided it was time to update my old workhorse the MakerGear M2. This mount allows the addition of a BLTouch sensor without loosing too much useable bed space. I'm running this with Marlin 2.1.2 and here's a link to my config files.…
My TFT screen required more clearance for the mounting depth. Moved the surface down 1mm. Also recessed the 3mm nuts 3mm deeper to use 15mm length hardware. Print Settings Printer Brand: MakerGear Printer: MakerGear M2 Rafts: No Supports:…
This was remixed to allow for use of 1.25" aluminum angle. Added a notch on the bottom to clear the wires on the stepper motor. Also the holes have been moved for the 15mmX20mm drag chain found here:…
This is a remix of the rsilvers E3D v5 filament drive. Provisions have been made for the PTFE tube and Bowden connector on the 1.75mm universal hotend. Category: 3D Printer Parts
This mount is intended to glue into your aircraft and allow mounting of the Matek F411 Wing flight controller. Category: Models
This is a mount made to hold the following LEDs: http://www.readytoflyquads.com/led-decoration-board-set-7-30mm Will fit both the QAV210 and the QAV180 from Lumenier. Category: R/C Vehicles
To wszystkie aktualnie dostępne wyniki.
