Liczymy pasujące modele…
Rack stop is used in a wood working vise in the opposite side form your work piece. this keeps your vise jaw relatively square against your workpiece for better holding. 7 different thicknesses from .25" to 1.75" I have not printed this…
scope throw lever for Leupold Rifleman 3-9x40 designed to fit over a 36.2mm adjuster. I used a M3x8mm bolt, but you could probably use a 5mm I added two M3 washers in the gap to prevent over tightening the ring two edges would not take a…
Allows you to connect your antenna feed line to your antenna without cutting up coax. You will need a SO-239 bulkhead connector, a couple 3mm screws with nuts and washers, also a small ring terminal to connect your shield wire to one of…
This is my version of a wide clamp for the Wolff Twice-as-Sharp scissor sharpening system. this is for sharpening chisels or plane irons. I didnt want to pay the ~$80 for the factory clamp.…
Based on https://www.thingiverse.com/thing:4857561 I found the fold down flap didnt extend down very far. i cut some material away so that the flap folds down to the ground with 120 mm tires. Category: R/C Vehicles
I have not printed this yet. Used when installing ¼" toggle bolts, uses a 9/16" hole instead of ½". Just push it in your hole, insert toggle bolt and it will keep it from spinning when installing.
holds an adhesive backed 50x50 LED COBB https://www.amazon.com/dp/B01LW2NBK6 print the cover in a clear filament Category: Automotive
To wszystkie aktualnie dostępne wyniki.
