P
PrintablesDMT_ZA
INGCO 20V Tool - Workshop Holders / Brackets - V2 (Upright Remix)
Rotated and rounded edge removed to be printed upright without supports and better layer adhesion in direction of pull.
- Pobrania
- 456
- Polubienia
- 20
- Ocena
- 5
Wszystkie modele
Liczymy pasujące modele…
P
PrintablesDMT_ZA
Ryobi Mini Tool M18 Router Attachment - 60mm base
Router attachment for Ryobi CHT-40K Mini Tool. Interface: M18, 1.5mm pitch, fine thread. 60mm base diameter. The Freecad model is included - adjust as needed to fit your tool.
- Pobrania
- 132
- Polubienia
- 40
- Ocena
- 5
P
PrintablesDMT_ZA
Nozzle torque wrench (2.5Nm rotor)
This is a 2.5 Nm rotor for the original model from Patrick Harrer . The rest of the tool models can be downloaded there. This rotor was printed and tested with white eSun PLA+. The FreeCad model is included should you need to adjust the…
- Pobrania
- 85
- Polubienia
- 7
- Ocena
- 5
P
PrintablesDMT_ZA
Carburettor Choke Butterfly Shaft
Disclaimer: This model comes without any guarentee of fitness for use with your engine - use at your own risk of engine failure. Material : A word of caution first! For a permanent solution a strong, high-temperature filament with…
- Pobrania
- 49
- Polubienia
- 2
- Ocena
- 0
P
PrintablesDMT_ZA
3.5" Hard Drive Mount Slider Bracket for a CoolerMaster PC Chassis
I drew this model from an original bracket that came with the Cooler Master PC case. Other models that I found online were too long and did not fit into my case. The bracket works for the left and right side. PLA may become soft or deform…
- Pobrania
- 42
- Polubienia
- 2
- Ocena
- 5
P
PrintablesDMT_ZA
Toyota floor mat grommet / eyelet
Eyelet for an after-market Toyota driver-side floor mat to ensure the mat stays in place. Updated V2: Added model with a keyed surface to keep twist lock in place. Print material PLA may soften when the vehicle is parked in the sun.…
- Pobrania
- 38
- Polubienia
- 2
- Ocena
- 0
P
PrintablesDMT_ZA
CI Gypsey Caravan Floor Vent Hatch
The model attempts to be true to the original vent dimensions to allow interchangeability with the original parts. There are two versions of the frame, one with, and one without, a chamfer at the floor edge. For the bottom (underside)…
- Pobrania
- 27
- Polubienia
- 0
- Ocena
- 0
P
PrintablesDMT_ZA
Falcon model RC aeroplane under carriage
Falcon model RC under carriage
- Pobrania
- 16
- Polubienia
- 0
- Ocena
- 0
To wszystkie aktualnie dostępne wyniki.