Liczymy pasujące modele…
This compact funnel fits right into the side of a camper to allow pouring in the water from a bucket to fill the tank. Neck is 29mm about 1-1/8". Printed upside down without support fine. Print Settings Rafts: Doesn't Matter Supports:…
A bit tough to print, but using a brim keeps the legs all in place.
My air nailer upper stop bumper cracked so I drew up this replacement. Works well in a Campbell Hausfield framing nailer and should be the same as other brands. Printed in TPU. Print Settings Printer: i3 Rafts: No Supports: Yes…
Keeps the door 65mm off the wall so the door handle doesn't hit. Print from PLA or PETG works ok. Thicker walls makes it stronger.
A handy keeper to help secure the door of a Weber gas BBQ. This prints well with PLA and snaps to the handles on the front and keeps them closed in the wind. My old grill has been through a few such windstorms and the magnets are not…
This single part clips over a Leviton plug available most places and supports it when pressed into a panel. I've printed it with PLA and there is enough flex that the plug securely snaps in. There is tabs 25mm back to support it in 1"…
To wszystkie aktualnie dostępne wyniki.
