Liczymy pasujące modele…
Practical remote control holder simple and elegant, but at the same time a piece of furniture with its sinuous lines that intertwine giving life to a real piece of modern furniture. Printed on the unsupported side with 3 walls and a 20%…
This test allows you to understand if your printer is set well in the slicer from the dimensional point of view of the holes, as well as checking the real measurements of x, y.
parkside x20v wall battery holder customized with embossed writing so you can print the logo in a different color to highlight it and give a touch of color to our garage. Petg material, 20% filling, 3 walls.
Quick and easy accessory to hang our 4ah x20v series battery chargers on the wall, molded in petg 70% gyroid filling
reel holder for 2020 profile with 4 fixing holes, petg, layer 0.28, walls 3, filling 20%.
modello da stampare in pla con i più svariati colori ,senza supporti riempimento 10% pareti 3
support for BLtouch on ABBN 30 afterburner, side mounting, unfortunately the bracket is 8mm higher than it should be due to the type of support itself, therefore I recommend putting 3 M3 nuts between the support and the bl touch ... (see…
table stand for Dremel tacklife 3,4V, printed in petg or pla, 10% infill, 0.28 layer height, 2 walls.
surface printed without supports preferable petg layer height 0.2
chip suction cone, practically mounted at the base of the worktop through a hole, becomes a real vacuum cleaner, connecting a suction pipe to the base of the 40mm diameter cylinder. Petg material, 0.28 layer height, 3 walls, 30% infill.
printed with the part of the 2 holes on the printing plate without supports layer 0.20 recommended material petg
To wszystkie aktualnie dostępne wyniki.
