Liczymy pasujące modele…
Mount for console controllers that has a ball-end that works with RAM mount arms . 2 sizes available. the ps4 version is a kitbash of Akaki's mount piece, so it is a bit of a mess, but works.
designed to fit the common HW-504 thumbstick. The thumbstick should snap into place with moderate pressure and hold solid. the shell snaps together as well. There is a base with screw holes just in case your pcb is a different size than…
These are replacements for the stock thumbstick toppers. You will need to open your controller to remove the existing thumbstick topper to use this. They slide on, a very tight fit, so they will not fall off. If your printer is not dialed…
prints fine on my Mk4s without supports at .15 layer height. My PLA prints were a bit too brittle, I'd recommend other materials such as PETG or PCBlend. ABS would probably be fine This allows for very strong attachments to the thumbstick…
new toppers for the Playstation Accessible Controller. Up first, a “goalpost”. This replaces the joystick topper with one that is ergonomic and helpful. I recommend printing this at a 45 degree angle(or on its side) in order to get…
uses this exact model https://www.adafruit.com/product/444
This modification works for this specific model: https://www.amazon.com/Logitech-Joystick-Programmable-Weighted-Rapid-fire/dp/B00009OY9U/ You only need to print it, then use a zip tie to hold it all together on the joystick. The 2nd,…
This a system that allows you to position 4 to 8 buttons. Designed to be used with the MS Accessible controller, Playstation accessible controller, or hori flex. Each of the button blocks pops out so you can rotate it to determine the…
the buttons on the thumbstick pod are very easy to accidentally hit. This cap blocks the buttons for carefree gaming print it upside down, no supports required. To install just pull off whatever topper you're using and slide this over the…
To wszystkie aktualnie dostępne wyniki.
