Liczymy pasujące modele…
This is a "generic" table clamp, with a simple connector slide. A "headphone hanger" is here as an example of usage. Print instructions Nothing special, I printed the clamp, on a 45 deg angle "on the back edge" which removes the need for…
After many many years of just working on my MacBook Pro, I finally got a “Magic Keyboard" and “Magic Trackpad” and started working in a more “Desktop kinda way”. But the Trackpad was never where i wanted i to be… So I created this “Thing”…
No more Ratteling This is a simple ring that fits around the bottom of the gas canister that prevents the “infernal” sound of it moving inside my Primus or Jetboil stove. I use id for the 100g canisters as they fit inside my stoves, but i…
Some time ago I created the https://www.prusaprinters.org/prints/61596-magic-keyboard-and-trackpad-thing to fix the relative position between my keyboard and track-pad, to simulate the experience of working on my MacBook Pro.. Then not to…
Knob for a outdoor water faucet, fits on 8mm sub with center-screw Printed mine in PETG, should print either side up, with minimal supports..
For mounting a laptop on the back of a monitor, not pretty, just works.. Fits any laptop below 20mm in depth. Works just fine with my MacBook Pro Print instructions Noting special, if printed upright, it prints with no supports. I opted…
Well, I wanted to take out my old Burton board for a spin, but I only have NOW bindings at the moment. NOW does not sell a mounting plate for their bindings that match the old Burton 3D hole pattern. So I created one. I have Printed this…
While setting up our new kitchen, those little things for holding the shelves were missing, so printed some They fit in a 5mm hole in the sidewall, and hold up nicely. Created a 2nd version with the possibility to add some screws, if that…
Inlet Converter This little gadget makes it possible to inflate a “Tlt Hvil” mat using the “JR Gear Dry Pump MK2”. It is a simple little thing, and well.. easy to bring and Printing Printed this in medium-flex TPU at 0.2 mm no supports,…
Cover for My Skullcandy Vert headset. I cannot count the number of times the headset has been turned on (or off) in the bag or in my pocket. So created this small cover, mostly meant for transportation but the headset is fully functional…
To wszystkie aktualnie dostępne wyniki.
