Buisness Card Dispenser
Buisness card sipenser to show make your cards be presented in more fun way. Enjoy:)
- Pobrania
- 386
- Polubienia
- 74
- Ocena
- 1,5
28 modeli
Buisness card sipenser to show make your cards be presented in more fun way. Enjoy:)
Dwight Schrute Buisness Card Holder : Touch Up. But the bottom of the glasses still need to be thicker.
This is small case to protect up to 5 buisness cards. For presentation, you can slide the card out to the right with your finger. Card dimensions: 85x55 mm Print Info: Printed with PETG (other Material has to be tested) layer height 0.2…
For Buisnesscards with an diameter on 55 x 85mm. The model dose have holes for magnets (diameter 3mm depth) but it actualy dosnt need them to stay shut. Print settings (recomended) 2mm layer hight no support
I made this to hold the a business card in place while engraving. The air assist would blow them around. It also holds the card higher to make it easier to focus the laser.
Print on side but with support, i do 100% infill more pictures will follow
This model is designed so that you can use both parts (top and bottom) to hold cards while playing. When your done playing simply just put the two parts together and they will hold together. Just be carefull when opening and closing,…
This is a model I created while living in student housing with a small desk setup. It was convenient to mount as much as possible on the wall to clean up desk space, so I created this to keep all the business cards. The model is designed…
I made this for well my buisness lol.
V2 of our Rocket Buisness Card Holder. A little more streamlined for hopefully better printing results.
Print on side but with support, i do 100% infill more pictures will follow
Business card and pen holder
Simple buisness card holder for your 3d printer. Requires supports. Slides into 2020 extrusion and mounts without any screws. If it doesnt fit for you scale it down a 1% or 2% and you should be fine. Fits typical sizes of buisness cards…
Print upright but with support i do 100% infill more pictures will follow
Follow me on ig: @ 3d _earth_
its a buisness card holder with anchors and its a little hard to get balanced
store your yubikey in your wallet along with other credit cards
blow your clients away with this fun card
This holder was specifically designed for cards the size of 89x51mm, but any a bit smaller of bigger should still fit! I also added a small angle of 8°, so the cards are easily visible and accessible while remaining securely in place.
Simple card holder and dispenser. Load and take out through the same hole
Buisness / Calling card Holder. Fits the EU Standard Size. (85 x 55 mm) Recoment at least 20% infill and gyroid pattern to give it some weight.
Print upright but with support i do 100% infill more pictures will follow
This holder was specifically designed for cards the size of 89x51mm, but any a bit smaller of bigger should still fit! I also added a small angle of 8°, so the cards are easily visible and accessible while remaining securely in place.