10 modeli
-Printed with 15%infil with PETG or ABS(PLA gets too hot in the sun and deforms/cracks under recoil) -4mm roof/walls Slightly oversized so it needs a slight sanding to get it perfectly flush
The CAF C7A2 replaced the C7A1 quite a long time ago. One thing they never really solved to my satisfaction was how the old c7 had different length butt-stocks to adjust length of pull for individual shooters. It also makes parade drill…
3d model of a original wooden CETME C stock. Print butt pad in tpu, adjust walls and infill for desired squishyness, fuzzy skin works nicely on the butt pad.
You can either print it and stop to add the steel washers of the original model or use a smaller washer and push through the top with the screw you will use. Print in TPU using a 35% infill i was able to get 95A to squish and remain strong.
Based of the stock butpad but increased to 45mm in length. please note that the end of the blaster isnt completely flat, so you might have to trim and/or shim the space between the blaster body and butpad for it not to wiggle around.…
Simple model to increase the LOP of your KRG Bravo. Fusion360 model included so feel free to adjust the height. Don't forget to get some longer screws!
🎯 Ultimate Buttpad Upgrade for Operation Ghost/Ghost Squad Lightgun! 🎯 Tired of your lightgun’s buttpad being shorter than your patience during a reload? Say hello to the Ultimate Buttpad Upgrade! Whether your original buttpad bit the…
TPU buttpad for AR-15 / M4 Milspec stocks. Made for my son's Airsoft M4 I use an IDEX printer and use PLA for supports (pop right out) Print Settings Supports: Yes Resolution: as desired Infill: As needed for desired firmness Filament:…
Made a simple thin butt-pad for the mpp cause the stock is slippery. Print in tpu and glue the pad onto the stock battery cover i roughed up the surface with coarse sandpaper and used CA glue but hot-glue would probably also work. i also…
