P
Printablesdennerlg
Halteschale für Zoom H2n
Da das Stativgewinde ausgebrochen ist, habe ich diese Schale konstruiert. Das Mikro kann ohne Schrauben leicht entnommen
- Pobrania
- 44
- Polubienia
- 4
- Ocena
- 5
Wyniki wyszukiwania: h2n
Liczymy pasujące modele…
P
PrintablesJoedazin
Tripod mount for Zoom H2n
The threaded hole on my Zoom H2n recorder was damaged (see picture). So I designed a replacement lid for the battery area that integrates a new threaded hole. The recorder can still stand, and the SD card slot remains accessible.
- Pobrania
- 50
- Polubienia
- 4
- Ocena
- 0
P
PrintablesWozzeck
ZOOM H2n case
This case holds a Zoom H2n recorder and some accessories (on the right part): typically an USB cable, spare batteries, a small powerbank, some SD cards… Note that powering the H2n from an USB powerbank removes the need for batteries. The…
- Pobrania
- 42
- Polubienia
- 4
- Ocena
- 5
P
PrintablesElias
ZOOM H2N isolator (shockmount) for camera hotshoe or tripod
An shockmount (isolator) for the ZOOM H2n. This design uses a silicone band (wristband) to hold and isolate the H2n. The silicon band should last longer than an ordinary rubber band. It should also be easier to put the H2n in the…
- Pobrania
- 38
- Polubienia
- 3
- Ocena
- 4
P
PrintablesFilip Rajnoch
Zoom H2n schock mount for microphone holder remix
The model is based on @Elias_344681 model I've changed to bottom mount part for microphone holder head, where the outr diameter is 22mm, the center hole has diameter 8mm and thickness 6mm. Model works with general silicone/rubber…
- Pobrania
- 10
- Polubienia
- 3
- Ocena
- 0
P
PrintablesManuel C. Senn
Zoom H2n Gridfinity bin
I made a custom Gridfinity bin to snuggly store a Zoom H2n audio recorder. I used the 3D scan model from 3DSCANPRO , and used Gridfinitygenerator to model a custom old into a bin. I made three versions : - without magnets/screw holes -…
- Pobrania
- 1
- Polubienia
- 0
- Ocena
- 0
P
Printables
Zoom H2n schock mount for microphone holder remix
The model is based on @Elias_344681 model I've changed to bottom mount part for microphone holder head, where the outr diameter is 22mm, the center hole has diameter 8mm and thickness 6mm. Model works with general silicone/rubber…