6 modeli
If you like me parts, you can also support me here: https://buymeacoffee.com/andretheengineer :) This is a very basic runoutsensor for your thumperblocks. Up front you should only do this with a fresh build. otherwise you have to remove…
If you like me parts, you can also support me here: https://buymeacoffee.com/andretheengineer :) If you like this one check out my even smaller runout sensor This is a very small inline Filament runout sensor for PTFE Tube. Print in…
Vorlage ist dieses wunderbare Design: https://www.thingiverse.com/thing:2633989 habe es in so fern abgewandelt das der Runoutsensor direkt vor dem Extruder montiert werden kann. Viel Spass damit ;-) Print Settings Printer: TronXY X5SA…
If you like me parts, you can also support me here: https://buymeacoffee.com/andretheengineer :) Hello, here you have a tiny runoutsensor. this is the smallest i could get them. You need: 2x ECAS4 without rubber part 1x 6x3mm magnet 1x…
Filamentsensor für Fehler am Durchmesser und wenig Filament. Es werden 2 mechanische Endschalter benötigt, diese parallel anschliessen. Oben etwas PTFE Schlauch einsetzen. Hier läuft das Filamt zuerst durch. Bei zu großen Durchmesser löst…
IMPORTANT!!! the sensor has to be installed before the extruder not after Additional Hardware u should have everything u need after some time of owning a printer but if not here is the list 1x sensor 2x m2.5 screws (the ones from the…
