Wyniki wyszukiwania: tailpiece

Sortowanie

9 modeli

P
PrintablesMMDeveloper

Schlage tailpiece removal tool

It holds the spring loaded pin down and uses the rest of the indentations to spin the cap.

Pobrania
129
Polubienia
6
Ocena
4
P
Printablesscenek

Peugeot Expert Traveller seat bar tailpiece

Seat bar tailpiece for Peugeot Expert Traveller, Citroen Spacetourer and Toyota Proace. The original broke fairly easily. To remove the bar from under the seat, it is necessary to apply adequate force (the bar is springy) and to remove…

Pobrania
31
Polubienia
5
Ocena
0

Guitar whammy bar system tailpiece

This is my prototype for a 3D printable top-mounted vibrato/whammy bar system for guitars, inspired by the Bigsby design. Requires a spring about 1 cm wide to operate. Drill holes of desired screw size in the base to mount. This is a work…

Pobrania
24
Polubienia
0
Ocena
0

Truck Bed Topper Tailpiece

I needed this tailpiece to mount my new topper handles since the originals broke. Printed at 0.3mm height with 100% infill in PETG.

Pobrania
19
Polubienia
7
Ocena
0
P
PrintablesErickavu Amal

Violin Tailpiece - 4 STRING

Violin Tailpiece - 4 STRING

Pobrania
13
Polubienia
1
Ocena
0
P
Printablesbeandev

Saitenhalter - Tailpiece

You can change the parametric Fusion 360 model to configure it for your musical instrument. Instead of a high infill, please use a wall thickness of 3. Then it's enough to have 10% to 20% infill. PLA+ is ok for the model, but please add a…

Pobrania
13
Polubienia
0
Ocena
0
P
PrintablesMupshot

dishwasher tailpiece 22mm adapter

I was looking at the hardware store for a small adapter for my dishwasher to connect to a new drain tailpiece. the old one had a different dimension than the replacement. rather than fudging with an overpriced piece of hose, I went back…

Pobrania
12
Polubienia
0
Ocena
0
P
PrintablesJG 3D creations

Bathroomsink tailpiece

Our bathroom tailpiece broke off and I made replacement. I tighten it by hand. Printed from ASA, but I think that any material except PLA would be ok. Print profile 0.3 mm - draft, perimeters set to 3. Printing time is approx. 3 hours.

Pobrania
12
Polubienia
1
Ocena
0
P
Printables

Guitar whammy bar system tailpiece

This is my prototype for a 3D printable top-mounted vibrato/whammy bar system for guitars, inspired by the Bigsby design. Requires a spring about 1 cm wide to operate. Drill holes of desired screw size in the base to mount. This is a work…