Liczymy pasujące modele…
Hello, Today I have for you a Bracket with hooks 150x150mm. It is great for holding shelves, if you want to have a place for hanging. The bracket is 150x150mm , and the holes for the screws are 6mm with a countersunk. It holds really…
You can use these squares to easily level your bed. Print them out and then adjust each corner individually. If the surface is rough, lower that corner and if it's not sticking at all or you see gaps between the lines, then raise that…
Godzilla doesn't care about your holiday! Remixed this excellent coaster design into a Chroma Canvas image using black, bronze, tan, and white filament in a 150mm x 150mm square, which should leave plenty of frames to choose from. :) If…
150x150mm 1 layer test print
To mark a center, or cross cut, you need to print, two pins. Pins should be printed with 100 infill.
Very stable bracket 150x150mm with four screws (4mm) on each side for the perfect fastening
XY Calibration Cross 150x150mm Category: 3D Printing Tests
Step file included, so you can push/pull the bottom face to the distance of your liking. M3 x 10mm bolts and nuts for permanent installation. Dremel or similar to drill 3mm holes. Printing orientation for the joints: vertical, with brims…
Just a desiccant box I made because I was frustrated with other boxes. I sized it to fit between rollers in a large dry box. The lid doesn't fit quite right until both the box and lid are the same temperature so if you try and put a hot…
INFO A simple square plant drip tray. PRINTING No supports. Material depends if you want to use it indoors or outside. Brim depending on your adhesion but usually not required.
Laserrahmen für 150x150mm Laserbereich Faserlaser für ein Lochraster von 25x25mm M6 damit der bereich der Maschine nicht beschädigt wird. Ich habe ein 2mm Stahlblech eingeklebt und Schwarz lackiert damit ich direkt Magnete darauf…
Just a desiccant box I made because I was frustrated with other boxes. I sized it to fit between rollers in a large dry box. The lid doesn't fit quite right until both the box and lid are the same temperature so if you try and put a hot…
PETG Print Settings: 0.04mm Layer height 3 Walls 5 Top and Bottom shell layers 15% infill IMPORTANT: If your filament is semi-transparent, then use the “thick” version as it otherwise would be kind of transparent and look bad as you'd see…
