Liczymy pasujące modele…
This allows you to use non-proprietary batteries in your Hyper Go 1620X series RC car without resorting to a Velcro strap. It also retains compatibility with the stock proprietary batteries. It will accommodate batteries up to 35mm deep…
For MJX Hyper Go H16H H16E H16P 16207 16208 16209 16210 rc car. Part Numbers: Front swing up 16210 Front swing down 16220 Rear swing up 16240 Rear swing down 16250 Most of the measurements are the same, a bit redesigned to be more beefy,…
Battery retention arm model can be found here: https://www.printables.com/model/645510-hyper-go-16207-16208-16209-16210-battery-arm Designed to snuggly fit a 75 * 34 * 26.5mm or 2.95 * 1.34 * 1.04inch battery pack This is the battery…
This model was designed specifically for TPU plastic. It molds perfectly to the shape of the body and breaks slowly. Everything is installed in its original place. The cover is slightly larger than the original one, which better protects…
Taken from here: https://www.thingiverse.com/thing:5674578 For 16208 and 16209
Allows you to use bigger batterys and fix the battery cables Thanks to @RabidBadger_397944 for the first design.
I had to add a cylinder so that the bearings sitting surface would be smaller. Small mods from the original, but they actually make the model usable. I used it for MJX Hyper GO 16208 Its tested ad it works. i dont know how durable will…
It’s a replacement part for the shock attachment on the MJX Hyper Go 16208 1/16 RTR or probably any of the other hyper go 1/16 RC’s Any material To make it little stronger print with one wall and a 100% infill pattern Print horizontally…
Replacement for the front suspension guard for your shock eye. PETG or TPU reccomended If not lost you can use the replaced screw of the wheely bar ;-) Dont use the same hole like the screw from the front.
The model is designed to hold the battery in place. The front part is designed to prevent damage to the battery in the event of an accident with the RC car. When installing this holder, you need to remove the original holder. Mount the…
mjx hyper go 16208 and same front dumper part - 16101
The model is designed to hold the battery in place. The front part is designed to prevent damage to the battery in the event of an accident with the RC car. When installing this holder, you need to remove the original holder. Mount the…
This model was designed specifically for TPU plastic. It molds perfectly to the shape of the body and breaks slowly. Everything is installed in its original place. The cover is slightly larger than the original one, which better protects…
