Liczymy pasujące modele…
The case was originally design to be printed standing, with TPU 95A, it could work without supports depending on material and printer. Choice of 2 thicknesses: 1mm or 2mm Inside section: 50,90x58,2mm Do not hesitate to leave your feedback…
Created in Fusion 360. Protector for my little transtec beetle with DJI Air unit. Print instructions Needed a protector for FPV landings - cause the batteries get damaged over time, so I designed this in Fusion 360 to protect the lipo at…
This is a LiPo battery protector/bumper. After puncturing a battery during a crash (dangerous stuff) I tried finding a suitable protector for my batteries, but I couldn't find one. This will fit a CNHL MiniStar 650mAh 4S LiPo battery, but…
Protect your 4s 650mah batteries from getting scratched up on your emax BabyHawk R Should also work with most 3s and 4s lipos less than 31mm wide. Hole designed specifically for 15mm battery straps. If your battery strap is wider than…
Pour protéger vos lipos 4s 650mah LIHV Gaoneng
Designed specifically for the Anker Prime 27.650mAh/250W power bank and a tripod with the center column of ~27mm. The mount is designed to be attached/detached to the center column with a bit of force.
Print on its side with 100% infill. Holds the batteries with a solid clamping force. You can reinforce it with an elastic band if you want. Requires those super small M1 screws that come with the frame.
The case was originally design to be printed standing, with TPU 95A, it could work without supports depending on material and printer. Choice of 2 thicknesses: 1mm or 2mm Inside section: 50,90x58,2mm Do not hesitate to leave your feedback…
