Liczymy pasujące modele…
Description I had issues with the rear betweener not fitting nicely because of the extruder cable. I made the gap for the cable bigger while also extending the wall on the right side so that it fully slots with both lid risers on both…
Tired of using a flashlight to see your prints? I sure was! Can be printed w/o support. Can print 2 at a time on the K1 if you are careful how you place them. Based on JCs excellent lid riser and hinge! Requires soldering etc… for the…
Suggest to rear panel standing with supports. Print with ASA or ABS or it will warp if you print closed with high temp.
These tooth picks are really messy the have lying around. They do not stack, and is always a big mess. They kept on falling on the floor when I opened the door. 2,7 cm wide and 10 cm deep box. Box with compartments for each toothpick.…
You might've noticed the small LED strip that comes in the K1 just isn't enough. You could always install a longer LED strip on the back face of the frame. It helps a lot but there will always be a blind spot kinda area behind the hotend…
