Liczymy pasujące modele…
TinyMtn Free Pack 4 - Alaska This is a package with 3D model files for four notable mountains in the state of Alaska, USA. Denali, 20,310 ft / 6190 m Mt. Blackburn, 16,390 feet, 4996 m Mt. Foraker, 17,400 ft / 5304 m Mt. Deborah, 12,339…
white until 5.4mm red until 6mm green until 6.4mm light blue until 7mm yellow until 7.4mm finish with black
I didn't want to make these cages stick out any further than necessary from the fork so I made this adapter and used stainless steel hose clamps to secure the cage to the fork. I put Xpel chip guard film on the fork. I put VHB tape on the…
The Blackburn buccaneer-AKA Hawker Siddeley Buccaneer. Category: Vehicles
This is a one size fits all variant of my previous mount that was made to fit a Boosted Board. The c-clamp design allows it to fit different thickness of boards. You'll need an M3x15 bolt and an M3 nylock nut to complete this build (in…
This bracket enables you to mount a rear blinky on a Blackburn EX-1 or EX-2 bike cargo rack. Zip ties are sufficient but I recommend using glue (E6000) also. I have tested it on the NiteRider Solas and the CygoLite Hotshot
A simple mount for the Blackburn flea 2.0 that clips on to your boosted board electric skateboard. Added a new lower profile version that is still as functional as the original but with some excess fat trimmed off. Be sure to check out my…
Gcode is a Garmin twist-compatible mount for the Blackburn Dayblazer 800 bicycle light. STL is just the light section, needs to be mated to a suitable Garmin-compatible model, as referenced in this design. 4mm width zip ties to secure.
GoPro Style Support for Blackburn Dayblazer 1000 Bike Light Use temperature resistant filaments like PETG or ABS. The better orientation for printing is shown in the first image.
Replaces rubber end piece at the handle end for older style Blackburn FP Frame Fit Bicycle Pump. Printed in TPU, density is set to 30%, adjust to your preference. Glue in place with Silicone sealer or glue of your choice.
Blackburn Flea Tail Light Adapter to fit Topeak Explorer Rack with 50mm mounting hole spacing. This is based off the Cygolite Hotshot Pro Mount adapter, with the mounting channel widened to fit the spring clip on the Flea as well as…
This is a variant of my previous mount that allows you to adjust the up/down angle of the light. You'll need an M3x15 bolt and an M3 nylock nut to complete this build (in addition to the parts you print ;)) Instructions I've had great…
