Liczymy pasujące modele…
This is a replacement latch for the Carlson brand pet gate we've had for a couple years. After gluing the broken piece didn't work I pulled out Fusion 360 and within a couple of hours had a model to print. Update 3/31/2020: The initial…
Found a different Carlson latch here ... almost the same, but that was for the release button on the side, but mine is on top. This isn't a remix since the original was in F360 and my trial is up, so it was newly designed in FreeCAD. I…
This is a set of pieces that can be used to recreate the Cavalry Colonel (Colt Carlson) figure at 500% scale. This figure was released in 1996 and appeared in 4 sets between 1996 - 2002. All of the stl files needed to create this have…
Years ago we got this gate to keep larger dogs out and allow our cats free access, so it seemed like a good idea at the time to permanently remove the built-in small pet door. Flash forward to dog-sitting for a couple of smaller breeds,…
My Carlson Pet Gate latch failed after 2 years of use because the piece that allowed the release button to pull the latch back broke off in a way that wasn't fully repairable. I went ahead and designed a new latch and cover plate…
My dog chewed up this component as I was preparing to mount it to the wall. Print it thread side down with supports. Use plenty of walls/infill for strength.
Tisk z PLA, výplň 15%. Snadný tisk. Printing from PLA, filling 15%. Easy printing.
A model of the bakelite box used by Mr Carlson in his nixie tube frequency counter tutorial Use the EZM Electronic studio 1HZ to 75MHz counter kit, You will need to mount the power on and option push buttons on the underside of the board…
Replacement part for a broken hinge on the barrier. Hand modeled from the original part in Fusion 360. Print without supports (added structure for better bridge printing). Any comments and feedback is welcome :)
Hueforge photo of a sticker I have that found online. Project: joerogan.jpg Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 146.01x200mm in size You may print at higher layer heights below the…
The button stopped functioning on my pet gate and I couldn't open it. I owned it up and found that the button had cracked and the broken piece was preventing me from fully depressing the button. I redesigned the button in Solidworks and…
Years ago we got this gate to keep larger dogs out and allow our cats free access, so it seemed like a good idea at the time to permanently remove the built-in small pet door. Flash forward to dog-sitting for a couple of smaller breeds,…
