14 modeli
Centring angle for marking the centre or a 45 degree angle on round or square workpieces. There are two hexagonal holes on the underside for pressing in or gluing Ø7x1 magnets. Zentrierwinkel zum Anzeichnen der Mitte oder eines…
Wydruk około 2,37 €–2,90 € nettoWstępna wycena jednego wariantu
Introduction A multifunctional tool that allows the following 4 main functions for use in the workshop: 1: Protractor, measurement and drawing of angles. (0 to 180 degrees)*. Debossed legends are included to indicate the angle#. Radial…
The Centring Square is an essential tool for precision work. It helps you easily find the center of round diameters – perfect for drilling, marking, or alignment tasks. Why choose this tool? ✔ Always useful in the workshop and for 3D…
The design is based on the Longworth Chuck, it's a great movement and normally used for Woodturning. The chuck's original designer sadly died after showing the design at a club meeting. The late Mr. Longworth of the Hunter Valley…
I was annoyed by the rocking of the spools during printing. It also caused micro ghosting on my prints. Therefore, I designed this simple spool centering device. It is placed on the existing spool holder. The conical screws do the…
This version of the eSUN centring disk holds the spool firmly by mating up with the recessed 53mm hole. Modelled on the original 50mm centring disc, I created a new f3d model to make the re-design easier.
Shank size is 8 mm. It can easyly be changed into the file (centring-mandrel.scad). This is my first model with OpenScad.
Bucket with larger distance between hooks to accommodate wider T-Slot nuts.
I made this ring to take out the HPA engine play in the receiver or carbon tube, there are 3 dimensions you should check which fits you the best, and install that one. It makes the assembly a bit harder, but it helps in the alignment.
Our laboratory uses Greiner ThinCert inserts [6-well, Ø 24 mm, cat # 657638 (1)] as build surfaces for 3D bioprinted tissues created with our Aspect Biosystems RX-1 Bioprinter (2). They work wonderfully, except that the inserts do not…
Compact box to store the self-centring drill bits that I bought from Amazon (https://www.amazon.co.uk/gp/product/B0B5K23D1H/). Fits the 3 bits as well as the hex/allen key. I've added a tab on each end to stop the lid coming off so easily…
Lost mine the car would not turn. Created replacement, more variants. Has to go from inside. requires support, and maybe some adjustment, created more variants.
The TS-Optics focuser decoupling adapter with tilt flange (TILTRC8) is a worthwhile upgrade for GSO-built 8" RCs, including the StellaLyra, TS, Omegon and Astro-Tech versions. Fitting it means drilling three holes in the telescope's…
Centring angle for marking the centre or a 45 degree angle on round or square workpieces. There are two hexagonal holes on the underside for pressing in or gluing Ø7x1 magnets. Zentrierwinkel zum Anzeichnen der Mitte oder eines…
Wydruk około 2,37 €–2,90 € nettoWstępna wycena jednego wariantu
