Liczymy pasujące modele…
Ein druckbarer Gabelkopf für kleine RC-Modelle. Möglich wird dieser Druck durch die neuen Organischen Stützstrukturen ab Prusa Slicer 2.6. Wichtig ist, dass er in der skizzierten Lage (Bilder, Code) ausgedruckt wird. PETG ist als Filment…
I needed one for slab nerf gun because kit was wrong. Can properly be resized to the other sizes.
Evinrude Johnson 0322405 Electric Choke - CLEVIS, Plunger to lever Purchase at https://www.ebay.com/itm/133667880716
Printed flat on it's back without supports 100% infill and 4 perimeters, 0.2mm layer height. I used PETG for my print and expect it to last a while. It fit perfectly for my chair without any modifications to the part after printing.…
Needed a clevis for the concrete finishing tools to go on the pole I already have. Standard threading for mop and handles, clevis with carraige bolt square on one side. 10mm slot width a bit beefy to deal with my use case
Most GoPro mounts have one problem in common - they're tight, really tight and it can be a struggle to remove the GoPro when you need to change lenses, SD cards or access the menus, plus that problem only gets worse when its cold and the…
Remove the slop from your clutch pedal clevis with this bushing. I recommend printing with TPU or ABS for the best fit
Clevis for any M16x1.5mm threaded pneumatic cylinder. This isn't meant for heavy loads, I'm using it for linear motion. I printed in ABS with .2 layers, supports and solid. Seems to hold up just fine for my purposes.
Three-body clevis pin joint assembly: fork clevis, eye lug rod end, and cylindrical shear pin. Includes three STEP variants: • d12: pin Ø12 mm, total width 31 mm • d20: pin Ø20 mm, total width 52 mm • d30: pin Ø30 mm, total width 77 mm…
Remove the slop from your clutch pedal clevis with this bushing. I recommend printing with TPU or ABS for the best fit
1/10 Scale RC Clevis and Pin, Big and Small. Pin fits tight so no need to clip. Surprisingly strong.
Printed clevis pin, 38 mm shaft. You might have to scale it a couple percent to make it fit tightly. They are sized to work with the SALz HPA Nerf Blaster. They are not properly tested, but they do fit and hold up to the handling I have…
material: PETG layer: 0.2mm 1piece time: 4minutes 10pieces time: 25 minutes hopefully youll be as happy as me when i finally could assemble my plane :D enjoy
Overview This is a rod clevis that you can adapt to your needs. Open the “.scad” file, edit it, and generate the rod clevis you want. This model support insert. Configure the insert diameter and length on the “.stl” and generate it. You…
Simple replacement for the original E-flight clevis for the 1.3mm threaded push rod. I use it on my Conscendo Evolution, but should be same for other planes too. I included multiple hole sizes to make it work with your printer, it should…
