9 modeli
This is a holder for BAHCO sliding combination squares CS150 and CS300 for IKEA SKÅDIS pegboards . It uses Skadis T-Nuts for a very secure mount. For CS150 there's a single and a double version for one or two combination squares…
Just for holding the combination square on my wall of tools.
Description ESRack is a very good modular rack mount system created by @EvilProphet . I created a module for the MikroTik CR305-1G-4S+IN from the ESRack Customizable Device Mount by @DavidKahler_64887 The ESRack system includes the…
T-Slot badge reel holder adjusted to tip into the top of the gantry t-slot and remain in place without disassembling the gantry. Simple but effective retractable badge holder - a little bigger and a little heavier than others because I…
The CS30 stock ships with a mount for the Z endstop that is not moveable. This is a replacement, that will allow you to move it as necessary. Category: 3D Printer Parts
I designed this mod. Feel free to do anything you like with it, except no selling of printed parts or stls. This is a completely 100% reversible mod for the Creasee CS30. The CS30 usually has a Robin Nano v1.3 or a v2.0 board. These…
You can not use the stock filament sensor very well with a BMG Clone extruder on the Creasee CS30. The filament sensor sits about 16mm below the path of the filament in the BMG and it would be a nasty bend in the filament. This is a…
For the gate control that was always broken.
For the gate control that was always broken.
