17 modeli
Sharing my custom 3D enclosure design for the Lenovo M90q Gen 1, featuring the MSI RTX 3050 LP, a 3.5-inch LCD screen, and an RGB fan. This project involved designing the 3D case model using SketchUp and printing it with PETG filament on…
i made two silica gel beads container 1st one will fit on the side panels and the 2nd one will fin on the corners. i find it useful to keep filament dry when you are not printing. you need 1 m3 hex nut and 1 m3 10mm screw the container is…
Das ist ein Remix für 4mm Acrylscheiben (Türen und seitlich) Rückseite eine 15mm HDF Platte Rücksprung hintere Befestigung ist 18 mm so das auch eine etwas dickere Platte nicht übersteht Alle Teile müssen auch gespiegelt gedruckt werden…
Führung für obere Glasplatte des Sovol SV08 Enclousers. Mit diesen Keilen kann die obere Glasplatte des Enclousers, wie eine Schublade vor und zurück bewegt werden. Mich hat das Einkeilen der Türen immer ziemlich genervt. Guide for the…
Enclosure for USB hub, to be mounted on 50X30 profiles. https://www.amazon.it/gp/product/B07YCZTT92/ref=ppx_yo_dt_b_asi
is a prototype needs improvements to print the structure, a 0.6 nozzle, it tolerates bridges better, get used to the idea that it takes weeks to print, a single corner took me 16 hours, I had no intention of posting it but someone asked…
simple to print panel on the motherboard with an entrance to the pipe from an external fan from outside the enclouser. designed for an inner diameter of 32mm pipe
designed to be attached with m3 screws minimal supports required you can see my messy design in onshape
The fan-duct main body should be printed with PETG because the motor can heat up during long print. You need 2 M3 screw and M3 heat set inserts to fix the 5015 blow fan in place. Please check this video for printing in action:
TPU enclosure for a USB PD trigger board labeling imprinted. Print in TPU, secure cable and board each with a zip tie.
TPU enclosure for a USB PD trigger board labeling imprinted. Print in TPU, secure cable and board each with a zip tie.
Um die Temperatur zu regeln, habe ich ein kleines Display mit Elektronik eingebaut. Der Halter dient zur Montage im originalen Enclouser von Prusa in der Ecke an der Türe mit 60mm Lochabstand Damit es ordentlich aussieht, ist das Display…
TPU enclosure for a USB PD trigger board labeling imprinted. Print in TPU, secure cable and board each with a zip tie.
TPU enclosure for a USB PD trigger board labeling imprinted. Print in TPU, secure cable and board each with a zip tie.
TPU enclosure for a USB PD trigger board labeling imprinted. Print in TPU, secure cable and board each with a zip tie.
The key chain is designed to permanently embed a round RFID tag (diameter 25mm) during the printing process. The print must be paused at a specific layer so the RFID tag can be placed into the opening, after which printing is resumed to…
