5 modeli
This is a scaled flyable micro version of the ASW20 sailplane from Schleicher. The model was created to be lightweight and printable in normal PLA. Because of it's lightweight behaviour it's a little bit fiddly to get it together properly…
This is my first attempt at a Bambu Studio complete “project”. The model was colored, then disassembled to fit on multiple plates. You can reassemble the rocket in the software to see where everything goes. It's been cut to fit onto 3…
HUGHES MD - 500 (flyable pullcopter) Externals For launching the MD-500, you need to make the “ Overpowered Heli Launcher ” before: Printingsettings Print as light as possible. I used 2 perimeter, 0.2mm layerheight and 10% infill on the…
Modular rocket designed for motor 20mm diameter and 70mm length. Printable with PLA with brim, wall thickness 0.8mm i.e. 2 perimeters. No support. Parachute mounted outside the tube on upper aligner ring with wiring through whole in the…
1. Cover the Main Wing Apply a thin layer of glue to the top of the large front wing. Lay a piece of cling film over the glued surface and pull it tight so there are no loose areas. 2. Cover the Rear Wing Apply glue to the bottom of the…
