Liczymy pasujące modele…
Ruler with foldout stencils for kids. Printing Needed: 1x Top 1x Connector 1x one of the Bottoms Note: Can be printed without supports. Assembly Push the Connector through the front face of the “Top” part. Then push the Bottom part over…
NOTE: this project is based around M4 hardware, I release the CAD if someone is interested in making an imperial conversion or other tweaks, but I conceived this contraption in a very non linear way and the Fusion360 timeline reflects it……
The goal here was to design a table larger larger than the area of the print bed, but also to print it in one piece. The legs are also design to print-in-place and fold out to both allow for minimal supports and to support the fold-out…
Material: PLA Infill: 25% Outer Layer: 3 Printer: Ender 3 S1
This case was designed with onshape.com and printed with 98A TPU on a Prusa MK3s. SLICING By far the hardest part was removing TPU supports. You can bezel around the camera looks very rough. The whole case looked that way until I figured…
