Liczymy pasujące modele…
I saw this Thingiverse model and I wondered if I could make something like it for a Gladiator GearWall setup. Behold, it works and holds! I wouldn't hold a cabinet with these but most small tool organizers, power strips, power tool…
https://www.thingiverse.com/thing:2268473 is a fantastic Gladiator Geartrack Gearwall hook, the best I've found on Thingiverse and this remix does not try to improve it. Rather it adapts the solid connection to a different type of hanging…
Thank you @bummster for what is arguably the most sturdy and original-shaped hook for the GearTrack system. Thank you @elfie2002 for being one of the only shovel holders that is properly designed to be an absolute unit. This is literally…
Designed a Gladiator Gearwall filament spool holder that attaches just like other Gearwall accessories. The spool is held in place with a simple clip that slides easily in two groves at the end of the cylinder. The filament spool rotates…
Some items hang better on the Gladiator GearWall system when mounted sideways - parallel to the wall. This hook slides on from the side of the GearWall track and gives you that ability.
Wanted a way to store a few skateboards on GearWall without using a lot of space. Depending on skateboard deck/wheel height you should be able to stack them one above another. Will need to print with supports, print with skateboard…
Modeled up this adapter to use the EGO 765 Wall Mount on my Gladiator GearWall. Hardware: 1 x M4x10mm 1 x M4x18mm 2x M4 Hex Nut Screw holes are 55mm apart.
@bummster , again, thank you for the delightful hook design. @captainharlow , thanks for the vertical spool for the paper towels - I felt yours was definitely the most refined of all the ones out there. I've flattened one of the sides of…
Created a DeWalt tool holder in OnShape that snaps into the Gladiator Gearwall so the tool can hang flush against the wall. This one is long enough for a standard DeWalt drill. Printed in Elegoo Rapid PLA+, 0.2mm layer height, supports…
holder for ryobi tools to store them on Gladiator slatwall. I have not test printed it yet. If you print it let me know how it goes. Prints without support
Print the part as provided. It can be any filament you want except flexible. Glue may not be necessary since the layer lines oppose each other when assembled. But check to see if you can pull them apart. If so, then glue is needed. Press…
Filament spool rack brackets for the GearWall system. Use 1 ¼ inch PVC pipe for the rail
