7 modeli
3 different connectors for 65mm square drain/guttering. Easy print with only one of them (67.5 degrees one) requiring minimal supports on the inside. Print them from PETG with as many walls as you can. The pipes will be a snug fit and you…
I needed an adaptor from 68mm guttering to 40mm push and fit pipes. As i couldnt find anything in the local hardware shop and online options were quite expensive, i designed my own. Works perfectly and it was printed in PETG and then a…
Gutter size 38mm-22mm pipe diameter - 14.5mm
I needed a support for Brett Martin's Cast Iron Effect guttering that I could attached to an oak beam. So I designed this in OnShape. Works great, although I'm not sure the PLA used will be resistant to UV. Original design is here -…
I've designed this to use upcycled plastic yoghurt pots, attached to a length UK square line guttering, so that palnts can be grown by a hydropicics method. Each holder holds one pot. Each pot needs many holes made in it to allow the…
This is a replacement clip to secure PVC guttering together. Its tight tolerance keeps the rubber seal below compressed for water tightness. I was removing and cleaning my guttering when I broke a PVC clip, so replaced it with this one I…
Work in progress. Non-printable parts: 1 meter M8 threaded rod 2x 608 bearings 4x M8 hex nuts 4x M5 x 40mm bolt 12x M5 hex nuts elastic bands 4x small 10mm ish long countersunk self tapping screws Category: Engineering
