Liczymy pasujące modele…
This is an upgrade for HCMaker 7 3d-printer. With tennis ball feet it is possible to place all electronics under the table. So here are mount brackets for PSU. Print two of each. You also need 4pcs t-nuts (M3 or M4) and 4pcs screws 8mm…
Final part for my "no-box" upgrade. requires 2pcs M3*8mm and 2pcs M3 t-nuts (or printed t-nuts https://www.thingiverse.com/thing:3050607 ). Printed front side down with PLA. Supports needed. Check out my other designs in HCMaker7…
Recently I dropped filament spool on a Y-endstop. It bended a little. So I decided to make some safety covers for my printer. Here is left X-belt cover Printed left side down with supports Single M3 screw with nut is needed. Category: 3D…
Cover for y-belt and y-endstop. requires 2pcs M3*8mm and 2pcs M3 t-nuts (or printed t-nuts https://www.thingiverse.com/thing:3050607 ). PLA. no supports. Category: 3D Printer Parts
Finally I've got it working. So... Important notes : I might forget something or write wrong screw length. Excuse me for that. Next time I disassemble it, I'll measure correct length. I used screws DINs from local store. You may try other…
This is an upgrade for HCMaker 7 printer (ADIMLab Gantry). Undertable mount bracing for HJC2560-C board. Print 4 pcs. You need: 4pcs M3x6 screws 4pcs M3x10 screws 4pcs M3 t-nuts. Printed t-nuts are here:…
