Liczymy pasujące modele…
I wanted to organize my ink drawer, and I couldn't find anything that would fit these gorgeously shaped bottles. Prints in two parts. I printed this in local recycled PLA, 20% Quality settings in PrusaSlicer. 15% infill, no supports.…
This is a cap for the Iroshizuku 50 ML bottle. Mine broke, this one works great, you just need to save the paper/plastic top that goes on the inside to seal. Print instructions Category: Office
Basic stand to hold a couple bottles of Pilot Iroshizuku. Nice to keep them off your desk in case of any spills while filling or just to look a bit nicer and more organized.
This stand helps support and stabilize Pilot's Iroshizuku 15 ml ink bottles while filling your fountain pens.
Made the 50 ml bottle so I obviously had to also make the 15ml bottle as it's smaller and more easily left on a desk
Modeled the 50ml bottle of my Take-Sumi from Iroshizuku Fountain Pen Ink with an 18mm hole so it should fit most pens. Fits my TWSBI Eco just fine and I put a spot to put a sticker if you wanted because I wanted it flat rather than…
