Liczymy pasujące modele…
Minimal hangers for power bricks. Kessil A360X Reef Octopus Varios 2 Neptune COR-20 Updated to have more room for screw heads. Print instructions Prusa Slicer defaults w/ supports everywhere PLA will eventually warp from heat. PETG avoids…
A shade for the Kessil H80 LED grow light to prevent light spread. 90mm top to bottom with cutout for cables/ bracket. If you need a different length let me know
A request from a friend. The light pops right in. should be printed in Petg or something more tolerant than petg. source file included for remixes
Kessil AP9X Extruded Aluminum 1010 Mount
This is a mount for Kessil kight power supplies to be mounted on the wall to ensure if a tank leaks, the electronics will be protected. This was made specifically for the H380, but should work with the A360x. Printed in PETG.
A simple bracket to mount a Kessil A260XE on a 2020 extrusion. Print it on the flat side. I did not need supports, but your mileage may vary.
Mounts a Kessil A80 between overhead 8020 20 series, 9" spacing. M5 hole. Use a heat tolerant filament, ASA or ABS preferred.
A bracket to hold a Kessil A360 refugium light over a refugium. This model is designed to cover a 16" span and handle 1/4in thick walls. Print two copies of the legs, legs push-fit into the ring. Use ABS or PETG.
Converts Kessil LED Threads (M10x1.5) to standard microphone stand thread (5/8-27). I'm using these on Kessil A80 LEDs and amazon goosenecks (https://www.amazon.com/dp/B0D2938FZZ).
This adapter can be used to fit a Kessil PR160L LED lamp into a PerkinElmer FL6500 fluorescence spectrometer. I've built it for the long-time irradiation of a sample in solution in a cuvette. The cuvette holder needs to be printed as well…
Allows you to cut and adapt the tubes of the Kessil mounting arm for wire management. Pipes cut easily with standard copper pipe cutter. For my 4 lights I used: 90->T->T->T w/ notch->90 OD to wrap behind Print instructions Print with…
A mount for the Kessil A360WE Power Brick. Uses two #6 flat head screws. Easy to print, nothing special needed. Print Settings Printer Brand: Creality Printer: CR-10S Rafts: Doesn't Matter Supports: No Category: Pets
Made a light shade for a Kessil A360x aquarium lamp. Good fit, does the job nicely! Made with Fusion360.
My aquarium lights sit above eye level and were annoying so I made a shade that attaches with magnets. My first version was printed in PETG and warped a little with the heat, so I added some ventilation and printed these in ABS with no…
Printed/tested with PetG. Other filaments may require scaling. Just a note for those who may notice a ‘spacer’ against the glass in the picture. That is actually a spray bar holder that I designed to minimize my glass mounted components.
