Liczymy pasujące modele…
UPDATED I beefed up the limbs a little to increase strength, also added a hole for a bolt to go through the middle leg as this part kept splitting at the layer lines. Print middle leg upright with foot on build plate and left and right…
UPDATE (2024/02/04) Updated all models AND added models as requested See: https://www.printables.com/model/750767-mathews-trx-series-grip-_updated-and-added-models/files ***************************** I made a simple replacement grip for…
UPDATE oct 22th , 2025: Check out new folder with updated files, requested files… *********** Must be printed with supports on the the build plate for the base. No other supports needed. BASIC GRIP is just a slim grip with the preferred…
By request: Archery Pocket Quiver with Mathews Logo. 8 mm and 11 mm is the diameter of the holes for arrows. For outdoor/3D you may use thin arrows so take 8 mm, for Indoor arrows or thick arrows take 11 mm. Other designs: Martin Archery:…
As previous model. Must be printed with supports. Any filament will do. Version 3.4 is the slimmest version, as seen in the picture. Version 3.3 is a thad thicker.
A decorative set to insert into the holes of the Mathews TRX 38 compound bow (and probably TRX 40 but I don't have one). Took me less than an hour to modelize and print (so why look at similar things on archery shops for around 20€…) You…
This is a simple replacement grip for the older Mathews Legacy compound bow. I designed this for a friend and it fit great. No need for glue or anything to hold it in place. I believe he said his bow was a 2004 model but wasn't totally…
Silent Connect system version.
a quick to print rounded end for a Mathews C-Stand arm. Printed on an Ender 3 Pro with a .4mm nozzle and .2mm layer height.
This is a 32 tooth, 20°PA, .91 module gear designed to replace the threading dial gear on PM1228 lathes. It has a 10mm bore and 4mm keyway. Category: 3D Printing
Simple insert for Mathews TRX 36 bow, inspired by some others I saw for the TRX 38 but could find anything for the TRX 36. Printed in TPU so it's a full push through piece so it's nice and secure, I'm pretty new to 3d printing but printed…
simple mathew branded hanger for my z7 extreme. simple. 2 dry wall screws, not much else too it lol. does it work on other bows ? no clue, give it a try. I didnt use any supports, 3 walls, 15% gyroid... holds my bow, all i need.
Simple insert for Mathews TRX 36 bow, inspired by some others I saw for the TRX 38 but could find anything for the TRX 36. Printed in TPU so it's a full push through piece so it's nice and secure, I'm pretty new to 3d printing but printed…
