11 modeli
The receptacle part of a self inflating mattress where the valve plugs into the mattress. Printed with garbage creality green pla.. rubber cemented in place.. holding up sofar.
Wydruk około 0,56 €–0,69 € nettoWstępna wycena jednego wariantu
Depending on the configuration of your printer, you should test the model by turning 180° and generate a partial print of both ends. This is a good way of finding out whether the dimensions fit exactly.
My mattress kept sliding out of the bed, so I modified an existing model to keep the mattress on the bed. I hope this helps someone. It was printed on ender 3 v2 PETG - 240c for nozzle, 70c for bed Triangle infill - 35% No supports. Layer…
I designed a matress stopper for the ikea malm bed. The angle is designed so that it catches the matress and brings it back in position when closing the bed. Prints in given orientation without supports. ♥ Post your makes, get…
Mattress on bed kept slipping so pillows were falling between mattress and headboard. A couple of these fitted to the end of the bed sorted it. If you have this issue this model may work for you but obviously designed for my ottoman style…
The 3D-printed air valves designed for pool mattresses feature design to enhance both functionality and durability. These valves are crafted using precise 3D printing techniques, allowing for a custom fit and a secure, airtight seal that…
0.2mm Later Structural PETG Supports,SNUG, everywhere, there are to specs which need blocking on autosupports. Brim is also advised
I was tired of the pump falling off when deflating and rolling up the matress so I created this one. I printed the part for the matress in tpu and used an o-ring in the crease. The part for the pump I printed in petg and glued them…
A fitting designed to adapt the small rubber nozzle that comes with the small Makita blower/vac to the OZtrail 3D Fatmat valve port to allow for efficient removal of the air for storage. It has been designed to work with the nozzle that…
My mattress kept sliding out of the bed, so I modified an existing model to keep the mattress on the bed. I hope this helps someone. It was printed on ender 3 v2 PETG - 240c for nozzle, 70c for bed Triangle infill - 35% No supports. Layer…
The 3D-printed air valves designed for pool mattresses feature design to enhance both functionality and durability. These valves are crafted using precise 3D printing techniques, allowing for a custom fit and a secure, airtight seal that…
