Liczymy pasujące modele…
Two of the change gears in the thread-cutting / feed gearbox on our Emco Maximat Super11 lathe at Stockholm Makerspace had broken teeth after a crash, and spares were very hard to get, so I designed and printed these change gears. They…
Change gears for Emco Super 11. There is also a stand for storage. Here are the print parameters I used, change as you see fit. I printed them one at a time to avoid any stringing/blobs on the outside of the gears. PLA 5 perimeters 30%…
Snap in T slot covers for the cross slide. Cut to desired length. Fusion360 file included if you want to modify. Print upside down as shown in photo.
Chuck spider for my Emco Maximat 11 stock chuck (EMCO/RÖHM) Chuck spacer is usable when you want to turn short stock in your standard chuck and can in some circumstances replace soft jaws. Part from the printed parts spider and spacers…
I have made a hole for a brass insert and you can put in a 12x5mm magnet with hole to secure it.
Emco St 33-02 Replacement Part Replacement part for the Emco Maximat Standard lathe (1960s), based on measurements from an original St 33-02 part. The download includes: STL file for direct 3D printing Fusion 360 file that is fully…
Spindle coupling for the Emco Maximat Standard Lathe. Mine was brittle and cracked while restoring the Machine. Printed it in PETG with a lot of infill, going strong since 2 years of occasional use. Hope this helps!
Our Emco Maximat V10-P had fenolic resin gear broken, so I've made new one. Adjusted to nylon prin (PA12) with 100% infill. I would recommend laso use JB Weld plastic bonder + pressed fit on original metal part. Works well still.
