Liczymy pasujące modele…
With this it is possible to mount 1 Spool inside the enclosure of the Mercuryone ZeroG without loosing build volume. It uses as much as possible of the original parts. Just the shaft that holds the roll was modified to fit inside. The gap…
This is a set of feet that work with the MercuryOne.1 base, and fits the standard Bambu P1/X1 Hula feet. Print in TPU, mount like normal M1.1 feet, and set on top of Hula feet. Should be a snug fit, but TPU will give it enough flex to set…
Just another modified version for the ZeroG MercuryOne.1 build.
mount P.I.N.D.A. (8mm sensor) for Voron Afterburner. It prints without supports and consists of a holder and a washer under the screws 2x thermal threaded insert M3, 2x screw M3x16 and 1x screw M3x12 and 1x nut M3 are used Category: 3D…
BTT or MKS mini12864 LCD display holder with ZeroG logo Prints without supports Category: 3D Printer Accessories
It is a buildplateholder for MercuryOne (Ender5 Plus) consisting of 4 parts to print it on any common 3D printer. The connectors are glued in and the edge should also be in the best case. Printer settings: Material: PLA+ Infill: 10%…
I ran into an issue where my auto-z-calibration was off due to some nozzle oozing… that caused my previous design to shift after the nozzle offset was too low and the nozzle dug into the bed. As a solution I created this brush mount to…
This is an improvement on my last design. It has a tighter fit to the bed bracket preventing any movement.
