10 modeli
That project was tested it's 100% work Printing: use PETG (remember that prefilter work in water whole time so I dont recommend PLA) 20% infill ( but this doesnt matter and so it will print 100% infill) no support or raft needed ( I print…
I broke the old one. So i try to make new and better one. I apply more and greater holes cause higher flow rate, i hope. Printed it PLA large 15mm outer brim slow down print about 50%
160mm Flange. Made to fit “Prima Klima Vorfiltervlies für K2600-100 & K2600-125 Aktivkohlefilter” and "Rhino Pro Vorfilter 255m³/h | Ø 100mm | L: 200mm" or similar Cage should be printed with Support, standing on the Flange. Lid seperated…
This is a perfect recreation of the prefilter used on any Dustbuster vacuum that uses the VF110 Filter. This was primarily made for the lower end Dustbuster models that did not include this prefilter. Of course you are free to print this…
Details On a small tank, the AquaClear intake reaches the sand. In addition to shortening the intake, this design allows a prefilter to be added to avoid sucking up small critters. I also sometimes stuff a wad of filter floss in it as a…
Lake water always has a few little things swimming around in it and it is nice to be able to filter them out of your water. This design lets you convert a bucket into a prefilter using a hottub filter and some M3 ready rod. The resulting…
Print as shown. Fits onto OEM intake snorkel. Insert spacer into base first, then foam filter, then attach lid. Without spacer the foam filter gets sucked into the intake.
Sundstorm prefilter holder replacment
I have the Marineland Penguin Bio-wheel 200 (up to 50 gallon). If you have a different size filter, make sure to measure your tubing first. Extending tubing allows intake to moved to the opposite side of the tank to the output for more…
Print as shown. Fits onto OEM intake snorkel. Insert spacer into base first, then foam filter, then attach lid. Without spacer the foam filter gets sucked into the intake.
