Liczymy pasujące modele…
About This is the first draft of a stationary or portable stand for a stack of Elecraft KX3 radio and Elecraft PX3 panadapter. The radio and the panadapter are stacked on each other, steeply raked, to create a compact and comfortable…
This is a set of magnetically attached covers for the Elecraft KX3 and PX3. These require common 6mm diameter by 2mm depth magnets. Designed in OpenSCAD. Since all KX3s and PX3s are hand assembled, I recommend trying the test print option…
This is a stand I designed for the Elecraft KX3 and PX3. You will need to print two of both STL files to make the stand. I forgot to add the cross brace for the bottom and back. My QRP Club the North Georgia QRP Club offers a very nice…
This pressure washer comes with a hardwired cord that's about 10 miles long, which gets pretty unwieldy when moving it around. This model adds a little “bollard” on top of the handle, which the cord can be wrapped around. The electric…
This is a stand I designed for the Elecraft KX3 and PX3 using Fushion 360. You will need to print two of each STL files to make the stand. I forgot to add the cross brace for the bottom and the back. My QRP Club the North Georgia QRP Club…
Sony ICD-PX370 Mono Digital Voice Recorder - Gridfinity
Remixed from APS UPS bracket with added holes for Eaton 9PX3000 UPS This is not intended to be used to secure weight but mearly stop the UPS from sliding about on its rails and ensure it's located in the correct position. Screws for APS…
Requires the GEMS Products Side KX PX3 End Panels: When in use, it snaps into the handle openings in the End Panels and extends upwards to shade your PX3 display from the sun. When you're packing up, reinstall it upside-down and it…
Printed in ASA for strength fill needs to be 45% or higher. The screws for the side of the amp are 10-32 x ½ long. Tighten the thumb screw on both the radio and panadapter prior to putting on brackets. the same brackets fit both.
The "Thrifty" PX3 Desk Stand is a simple, functional desk stand designed specifically for the Elecraft PX3 Panadapter. The design supports the PX3 using its built-in rear legs. This model was created as a practical replacement for a…
I printed these in Bambu Lab TPU 95A HF and, while not as tacky as the factory feet, they are functional. They also work printed in PLA in a pinch, but of course won't provide any traction.
The "Thrifty" PX3 Desk Stand is a simple, functional desk stand designed specifically for the Elecraft PX3 Panadapter. The design supports the PX3 using its built-in rear legs. This model was created as a practical replacement for a…
