Liczymy pasujące modele…
Mine did no stand up on its own because the feet were more turned inward. So, I edited the file, I believe yours will stand up on its own. Here is the AI / https://makerworld.com/en/makerlab/imageTo3d?from=makerlab Here is a helpful video…
This is a simple adapter from the 44.5mm diameter of the bottom of a crandall gas cylander to the 50mm diameter of a typical office chair base. The main problem with using these for any typical chair base is that they can be too long and…
Dieser 3D-gedruckte Verbinder ersetzt das PLAYMOBIL-Teil 3773 / 3002520 , das in Fort Randall (3419) und möglicherweise in weiteren Western-Sets verwendet wird. Der Verbinder dient zur stabilen Verbindung der Palisadenwände und sorgt…
Key for a School bell system timer, all but one of ours had been lost so created a backup. Designed to print without support. Instructions Printed at 0.2mm on a PrintrBot Simple Metal. Category: Parts
A replica of the smiley face pin worn by Randall Flagg in the 2020 miniseries adaptation of The Stand. I made a 1.5-inch and a 2.25-inch version. The 1.5 inch is the one pictured, and the one closest to the one in the series. They are…
plaque permettant d'intégrer des prises jack 6,35 à l'arrière de l'ampli. Ces prises jack supplémentaires permettent de pouvoir utiliser la partier pre-amp + power-amp de l'ampli avec un cabinet externe. Ou bien d'utiliser une tête…
Hueforge photo of a sticker I have that found online. Project: joerogan.jpg Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 146.01x200mm in size You may print at higher layer heights below the…
