Liczymy pasujące modele…
⚙ RECOMMENDED 3D PRINT SETTINGS Material: PLA or PLA+ recommended Layer Height: 0.16 mm for finer detail; 0.20 mm for faster prints Infill: 10–15% recommended for most models Wall Loops: 2–3 Supports: Enable where necessary based on model…
I do comprehensive 3D scanning and you can see some of my results here. The models are partially edited with AI due to small or missing details. If you are interested in my work and have a specific interest, you can write to me and my…
My wife broke the clip on her MP3 player, so I built a new one :) I printed it in PETG with 100% infill.
Keep your SansAmp V2 settings safe from accidental changes in your gig bag or on stage.
This thing saves the settings of knobs while the pedal is in bag or at gig. There are two models R4 and R5 - they differ by mounting type to the pedal. First mounting type(R4) is by control knob's nuts(it needs to remove knobs and nuts…
A replacement clip for the Sandisk Sansa Clip Zip MP3 player. Printed vertically in PETG for best strength. Supports needed when printing vertically (no supports needed when printing horizontally, back side on the bed). The hole for the…
Case for a first-gen Sandisk Sansa Clip. Used as a replacement for the back cover after destroying it to replace the battery. I printed it in clear resin for the aesthetic, but PLA works just fine. I recommend using the finest available…
I finally finished my player mod; it's only been a week. The stock battery showed 110 mAh under electronic load, and it lasted 13 hours on a Rockbox. This battery is from a 1000 mAh disposable cigarette(112040 format size), so I wonder…
Bring the Queen in the North to life with this stunning 3D printable STL figurine that captures every intricate detail of her regal presence. This masterfully crafted statue showcases flowing robes and elegant braided hair, making it an…
Fits Creality direct drive extruder Used Variable layer height to speed up print I have it in PLA for now until I get a new temp sensor that will read correctly so I can print in PETG. I would recommend PETG or higher heat-resistant…
updated my ender 3 pro satsana duct fan cover
Looking for a complete set of alphabet and symbol STL files? ✨ You’re in the right place! These fonts are free to use from fonts.google.com , but I’ve already done the work of converting them into ready to print STL files, all from 149…
Needed a power switch after opening my Sandisk Sansa Fuze. Printed in PLA with a 3 layer raft and supports. 0.3mm nozzle used, may work with 0.4mm
I would not print the clip on the back, or make it have a lot of infill, mine broke off and I glued it back on.
I would not print the clip on the back, or make it have a lot of infill, mine broke off and I glued it back on.
Game of Thrones - Sansa Stark (Sophie Turner) - 2011-2019 3D printable model.
