Liczymy pasujące modele…
This bracket is made for 10" racks. They have the standard dimensions of 1U (44.5mm) in height and 250mm in width. With these dimensions the mount can be printed on a print bed with the dimensions of 220mm x 220mm. The mount is designed…
The original design that had a large opening that could potentially let debris inside the operating mechanism. This version closes that up to only what is necessary.
It design not to be a tight fit (to prevent scratching), If you want more secure you can insert pieces of paper between shelve or use m3 screw on pre drill hole on top or below My print settings layer height: 0.2 wall: 3 infill: 15% If…
Based on the very good model of ER605 & OC200 Rack Adapters (V2) by Sorcier, I remodelled them to fit 2x TL-SG2210P. It's a heavy device, and 2 of them in this pair of brackets are recommended to be supported, either by support angles or…
SG22 Carry Handle with picatinny rail and fixed sights. 8.36 inches long, ideal for smaller printers. Open handle is easy to grip. Mount with 2 M4 screws and nuts, or similar in SAE
Barrel nut and 4.33 inch handguard for the SG-22. The nut uses heat set inserts for a more secure assembly. The nut has 4 holes every 90 degrees. Use a soldering iron to press in threaded inserts. There are two versions of the nut…
SG22 6 inch handguard with lower picatinny rail for use with grips or bipods.
6 inch handguard for SG22 with integrated foregrip.
As far as I know is this model compatible with the SG2210XMP-M2 and ER7212PC.
SG22 Carry Handle with RMR Mount and integrated fixed sights. Designed to work with the 7 & ¼ inch handguard . This is a long part. It will not print on smaller machines like an Ender 3.
I couldn't find a 10" rack mount for a SG2210P which was designed for the ports facing forward. This model has a gate at the back (press in using the bar closest to the "teeth") to stop the switch sliding rearward when you plug in network…
Holes are intentionally left small for a tight fit. print in the obvious orientation.
This is an SG22 6" extended handguard and barrel nut for airsoft.
Inspired by @RussellDame_2238247's 10" rack mount. Designed with a tight fit in mind so that screws are not needed to keep it in place. The base plate extends far enough to be supported by L Brackets on the back of most 10" racks. I am…
It design not to be a tight fit (to prevent scratching), If you want more secure you can insert pieces of paper between shelve or use m3 screw on pre drill hole on top or below My print settings layer height: 0.2 wall: 3 infill: 15% If…
I couldn't find a 10" rack mount for a SG2210P which was designed for the ports facing forward. This model has a gate at the back (press in using the bar closest to the "teeth") to stop the switch sliding rearward when you plug in network…
Slight remix of the original SG22 lower. Added text to compliment the remixed upper by kilgorenate, thing:5848205 or thing:5798052. Print with your typical settings for maximum strength. Category: Sport & Outdoors
