Liczymy pasujące modele…
HW modifications: Cut-off 5V traces 1) first between the temp sensor connector and the LED connector on the main board and solder 3.3V wire 2) Cut-off 5V trace (just under yellow wire) and replace it with 3.3V wire on the HMI board In…
I needed an accurate model of this display for designing a 3D printed enclosure for it. This is only a model of the TFT display. Download includes: .f3d, .step, .stl Edit: 2024-03-05 Due to an incorrect measurement the pin and mounting…
The front and rear are held together with 10mm x 3mm round magnets. There are cutout slots on each corner to insert the magnets then back-fill with filament from a 3D pen or soldering iron. The holes on the bottom of the case are for…
