Liczymy pasujące modele…
Inspired by Mass Effect game series. It's a complete model, not in pieces. Resin printers recommended for this model. I'm not pro so you can remix the file.
The back cover may be needed if the hole in the drywall was poorly done and extends outside of the switch cover. The insert should fit right on and will be held in place by the switch cover screws, just don't over tighten those. Print…
Best print in ABS or PETG with supports. Designed for Fat Daddy´s v4 low profile 510 and keystone battery connectors P/N: 228 and 209 Print Settings Printer: MakerFarm i3V Rafts: No Supports: Yes Resolution: 0.2 - 0.3 Infill: 30%…
Works for my SSX303 rifle, mine was broken into 2 pieces Culprits: side holes are swiftly bigger than the original, but works you may need to thread the main screw hole.
Mount plate to mount esc on rear difuser with wiring underneath right rear out drive. This mount allows you to run the power, motor, esc signal and sensor wiring underneath a place and underneath the right rear out drive on the YD2SX3…
FISHPRO Adapter for the NSX3007.. https://www.simrad-yachting.com/en-au/simrad/series/nsx/nsx-3007-ai-xdcr--ausnz-chart/
I recently turned my Paulimot/SIEG SX3L drilling/milling machine into a CNC version of it and althugh I attempted to mill all adapter plates out of aluminum, I got lazy and built the Y-axis out of PLA and now share the result here.…
My brother asked me to make this and there wasn't any models on internet so i designed my own. The stand is for novritch SSX303 . You will need 2 M4x16 screws and 2 M5 nuts . Hope this will help you. If you have some problems write it in…
UNTESTED!! Just made for fun! Print at your own risk ;-) Print Settings Rafts: Doesn't Matter Supports: Yes Category: DIY
This is a simple spindle lock for the SIEG SX3 milling machine. The lock goes over the splines to secure the spindle against the top enclosure. I printed this in PLA+ with 100% infill, you may be able to get away with less using a gyroid…
Printed with PLA and it works fine but might need to use a tool to get it off so maybe try PETG. STEP file included.
A frame you can glue or epoxy into your mod to hold your SX350 chip/ Instructions Test prints used ABS at an extruder temp of 220C on a heated platform at 110C. Be sure to set shells to zero or you'll end up with hollow walls. Category: DIY
Best print in ABS or PETG with supports. Designed for Fat Daddy´s v4 low profile 510 and keystone battery connectors P/N: 228 and 209 This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/ddIrrUAqpSo…
So I plan to design a mod to fit the YiHi SX330-V3B board. As i couldnt find anything around i thought i would measure out mine and start from there. This chip was taken out of a Sigelei 150w TC mod that has seen better days. Hopefully…
