Liczymy pasujące modele…
Taom remix to tighten up the fit of the standard round chalk to holder. Original design was solid and worked but chalk had a little too much wiggle room. I believe the original design was made/designed to store chalk while not in use to…
Hier eine kleine Dose für die runde Billardkreide von Taom. Ich habe das Gewinde nochmal nachjustiert aber nicht mehr neu gedruckt. Bei meinem Druck musste ich mit dem Cutter nacharbeiten. Zum Zeitpunkt des Drucks hatte ich noch keine MMU…
I moved to TAOM chalk and needed a belt clip for it. This will hold a TAOM v10 (haven't tested with other roud TAOM chalk, but I imagine it would work fine). Printed both parts out of TPU. .2mm speed profile @15% infill on a MK4 You will…
I switched from Kamui Roku to Taom V10 as my chalk of choice, and since I can't live without my Kamui Chalk Shark, I designed this holder! There is also a press fit lid included - please keep in mind that the press fit is optimized for my…
Addtional hardware required, 2 x M3 nuts, 1 x M3x12 bolt foe holding together the 3 pieces of the model and 1 x M3x14 bolt to pinch the model preventing the chalk from dropping out.
A Taom V10 chalk holder to utilize for storage. As well as the hexagon bottom to avoid the chalk falling off the table and rolling to obsidian. They say chalk is cheap, but this shit isn't. Protect it.
This single piece print is the chalk holder I use for my Taom chalk. Predator chalk also fits well. The print should be in TPU (or another flexible filament) at 0.2mm layer height with a 15x2mm magnet embedded midway through the print.…
Use it to store your Taom Chalk when putting it in your bag. 1/4 turn to open and close lid. Lid has knurling for easy grip. Hole in the bottom of the body so the chalk comes out more easily.
Designed this bracket to lift the STM preamplifier up on the ScientaOmicron VT-AFM XA. Both reducing strain on the cable and keeping it safe from being knocked around.
This single piece print is the chalk holder I use for my Taom chalk. Predator chalk also fits well. The print should be in TPU (or another flexible filament) at 0.2mm layer height with a 15x2mm magnet embedded midway through the print.…
