Liczymy pasujące modele…
Replacement stereo surround of for the Land Rover Defender TD5. Print instructions Material: PETG Layer Height: 0.3mm Infil: 30% Perimeters: 4 Top Layers: 3 Bottom Laters: 3 Support: Yes
Simply bolt it on an ordinary 6.5″ hoverboard hub motor and transfer the torque via a htd belt to drive everything you want.
Blanking plate for holes in the dashboard of the Land Rover Defender TD5 (This may fit other models) Print instructions Material: PETG Layer Height: 0.2mm Infil: 20% Perimeters: 2 Top Layers: 4 Bottom Laters: 4 Support: Yes
The radio holder in the defender 90 td5 was broken. So I made a replacement for it. It works also for the 110 defender.
I didn't find LR part number for this, but this part should be same as BMW 17111719190 Replacement for water expansion tank holder (bracket?). Should be printed from high temperature resistant material, because of higher temperatures in…
140t htd pulley for 5mm pitch 15mm width belt. Designed to be mounted to bicyle wheel with zipties. Made for Tom Stanton inspired ebike builds. Print settings Infill : 40% support : no speed : 50mm/s walls : 4 lines printer: Creality…
Description: This print replaces the factory ashtray in the Land Rover Defender TD5 with a clean, flat panel that integrates seamlessly into the dashboard. The panel provides a level mounting surface for GPS devices, dashcams, or other…
Designed to be used with 0.5" hex shafts with support for WCP-1121 3d print adapters to add even more support. Tested to be a nice press fit :)
A simple HTD 5M Sprocket. It can be easily fit on to a bycicle Wheel with zip ties. Print on 98,5% scale for belt fit. For use on my Ebike. Print the outter ring to adjust the scaling.
Oddly I needed it off-centered. Print instructions Licence: Creative Commons - Attribution Category: Robotics
V řemenici je otvor 4mm k motorům GA25-370. K zajištění řemenice k motoru vložte do vybrání v řemenici matici M4 a přitáhněte červíkem M4.
This is intended to fit onto an InnoGear microphone boom arm. The assembly mount consists of 3 parts, the microphone holder, the arm mount, and the spacer. The microphone holder is a little smaller than the microphone itself and has a…
Land Rover Defender - Clutch Alignement Tool Tdi/TD5
TD5 ECU Gasket (Work in Progress) A 3D-printable gasket for the Land Rover TD5 engine control unit (ECU), as fitted to the Defender and Discovery 2. The original ECU housing is sealed with factory glue. Once you open the ECU (repair,…
