Liczymy pasujące modele…
Description This is a wall mountable Nail Varnish / Polish Holder - suitable for several types of nail varnish pots including essie which it was original designed to take as it is based on my single bottle holder here:…
Something to help organise a number of beauty products. If I made this again I may change the stepping height for the nail varnish bottles to reduce the overall height, but it's no too big now. Print Settings Printer: Anet A8 Rafts: No…
Hi ! Following this guide i bought a chinese shaker https://s.click.aliexpress.com/e/_DCAxNMH https://www.fauxhammer.com/featured/best-paint-mixers-shakers-for-miniatures-and-wargames-model-paints-2019/ I bought this shaker, unfortunately…
This is a nail varnish holder designed specifically to accept and hold essie nail varnish/polish bottles but will also take normal nail varnsh bottles. It was made at the request of my partner who likes to get every last drop of varnish…
Corner angle is printed out of PETG and do not need supports. To connect the angle corner with the cardboard, I recommend to make a cut to the cardboard and flatten down crinkles for easier mounting.
Elevate your violin above your the surface. One part inserts into the endpin hole (must not have endpin in place to work), and the other supports the neck. This is especially useful when you are varnishing, as varnish is typically not…
Because I could not think of any useful Ikea Lack Model that is not already in existence I made this practical joke (which also conveniently holds tools too). In Germany there is a saying you can use when someone says something utterly…
I made this for my wife's Nail Varnish/polish as they were just rattling around in her top draw and it was bugging me lol.
Remixed from @alufers' Gridfinity holder for TermoPasty Topnik RF-800 flux . The 50ml bottle for TP Varnish PVB 60 is slightly wider than Topniks, and thus the holder needed enlarging. The STL made available has been exported with the…
Most distancers for painting have a spiked tip. This means, that the weight of your component is concentrated at a single point. These distancers have a slim, but long edge to reduce the load by distributing it along the edge-line. This…
i have paint the letters with a permanent marker and the result is not good… so, don't use permanent marker :( With PETG, i think is better to do that with acrylic paint for best result .. I joint the STL file without letters
Elevate your violin above your the surface. One part inserts into the endpin hole (must not have endpin in place to work), and the other supports the neck. This is especially useful when you are varnishing, as varnish is typically not…
While preparing to paint porcelain, I noticed that the varnish I planned to use was thick and had separated. To solve the problem, I decided to use a 3D printer's heating bed. I set the bed temperature to 80 degrees Celsius to heat the…
