Liczymy pasujące modele…
Multiple fan brackets for Velka 7 cases For 60mm Single Fan Bracket MB standoff mount: BOM: 1x M3x12mm screw 1 M3x16mm screw Instructions: mount fan on bracket mount bracket to stock motherboard standoff with long screw mount long case…
The HDPLEX SFX bracket has been out of stock for months after building a SFF PC in the VELKASE Velka 3. I opted to go with the Screw-Lock 7.4*5.0mm Female DC Jack option for use with a DELL laptop power supply. Covers the case's power…
Feet for Velka 7 SFF case. I had an issue when the included rubber feet kept coming off when I tried to slide the case across my desk. So I created this to give it a more stable platform and wider stance. Print fits as is. No supports…
Recommended, but optional print parameters: Textured bed for aesthetics (the bottom of the print is what's visible when installed) Heat resistant material (I used PETG) No supports needed
Feet for Velka 5 SFF case. I created this to give it a more stable platform and wider stance. Print fits as is. No supports required at all. Print it laying on its side. Recommended print settings: Infill: 20% Layer Height: 0.12mm…
3D printable handle for Velka 3/5/7 cases. Comes in 96mm (what Velkase sells) and 5in length (incompatible with Velka 3 side). Models accepting M3 and M4 (what the handle kit comes with) screws are provided. I also uploaded the .f3d and…
Fan mount to mount 2 A6x15s or presumably any 60mm x 15mm fan. mounts to the 2 holes on corner support bracket using one of the Velka 7 screws and an m3 nut. if a fan grill is needed, set the 2 parts over the fan to an infill pattern with…
Fan mount to mount 2 A6x15s or presumably any 60mm x 15mm fan. mounts to the 2 holes on corner support bracket using one of the Velka 7 screws and an m3 nut. if a fan grill is needed, set the 2 parts over the fan to an infill pattern with…
Should work just fine with the spare M3x10 screws included. Designed to be printed at a 45 degree angle to increase strength. Recommended print parameters: Print at a 45 degree angle to increase strength (helps prevent the handle from…
Feet for Velka 3 SFF case. I created this to give it a more stable platform and wider stance. Print fits as is. No supports required at all. Print it laying on its side. Recommended print settings: Infill: 20% Layer Height: 0.12mm…
