8 modeli
Because the original rear wheels of Neato and VR100 are very hard they make a big noise on tiled floor crossing the gaps between the tiles. If you print the attached file with white TPE and replace the hard wheels with the new ones, you…
A vacuum robot is a great thing and ours is so flat, it can even go under the couch. Unfortunately it won't find its way out and will get stuck, so I had to design an extension to the turret, so the safety switch will tell it to turn…
A nightmare to replace as you have to disassemble the entire machine…and Vorwerk did not design this to be disassembled. However, the part works astonishingly well for months now. Saved me 200€ repair cost Printed this in PET-G (solid)
Remark on the belt dimension After mounting the belt you must have a very tight fit on the pulley otherwise the motor will skip teeth under load (guess how I know that). With my robot, I ended up switching from the original 49 teeth belt,…
Rationale Those replacement rollers are slightly raising the front of the robot and lowering its back so that the main brush gets less friction on the floor. This prevents the brush from getting blocked and the belt to skip steps (can be…
Assembly Print x6 new flaps upright Pull out the x2 green end caps of the brush Slide the x6 old flaps out Slides the new in place Push the caps back in place (paying attention to the correct orientation: there is a small notch) Print…
Handle with attachment for vacuum regulator
Ein kleines Plastikteil welches verhindert den VR200 zu aktivieren. Zum Beispiel wenn man ihn versenden möchte - er sich aber nicht durch anstoßen einschalten soll. Einfach einsetzten und mit Tesa Film befestigen. A small plastic part…
