Liczymy pasujące modele…
Model of panel and clips for the top center console. This remix features 5 slots for switches and a non-visible mounting method. The clips can be glued to the backside with superglue for a clean installation. I printed it on a textured…
This is a model of Mercedes seal clip for W123 Coupe model, part number A0009871015 (for reference only). Measurements taken from an original part (see photo). I've used PLA for a prototype, then ASA for the final version, but I think…
Key case for Mercedes Benz Key W123 without pause. (If you need with a pause look at my Acc!)
This is a replacement adjustment bolt for the bowden cable that sets the shift points for the automatic transmission in the mercedes benz 300T/C/D w123 models with the OM617 engine. The slot in the side is so it can be installed without…
I found an stl of a clip that I needed for my W123, but it didnt quite fit my 250 model, so i changed it to fit perfectly! Enjoy!
Model of the panel and clips for the top center console panel. Print 2x clips and one panel and assemble as you like. I used pop rivets but would suggest screws and nuts instead. Front screw holes have a counter bore so you can cover the…
Print with two colours and sand the top to have a perfect finish. Orientate it either upside down or with supports. Print settings: Material: PLA Layer Height: 0.08mm Ironing: All Top Surfaces Infill: 100%
Key case for Mercedes Benz Key W123 with pause to insert key
A replacement for the ashtray in a W123 Mercedes. The shallow plate turns the space into storage. The extended plate is flush with the surface. There is excess space beneath the extended plate to allow for a 12v outlet or USB ports that…
Radialwellendichtring Antriebswelle Differential Einpresswerkzeug mit 100% Infill drucken dann hält das Teil auch Hammerschläge aus. Material PLA reicht…
Grommet that seals the windshield washer pump against the washer fluid housing. Print with flex filament, 100% infill.
Printed out of FilaFlex40, 100% Infill. When I was checking the vent line for the fuel tank on my W123 I noticed that mice had chewed away a good amount of the flexible bell that points downward to prevent debris from entering the vent…
soquete interruptor vidro esquerdo m.benz w123, w126
Je recommande d'imprimer en PETG, en ASA ou en ABS pour la résistance et la tenue aux UV. Je conseille d'imprimer à 100 % de remplissage avec des supports. Une impression lente pour une meilleure précision, et je déconseille d'imprimer en…
A replacement for the ashtray in a W123 Mercedes. The shallow plate turns the space into storage. The extended plate is flush with the surface. There is excess space beneath the extended plate to allow for a 12v outlet or USB ports that…
