7 modeli
Hang from a fishing swivel for best results- I used a piece of bailing wire down the middle and glued the joints a little. Not sure either of those things are required. I did make this one very large =P Approved by nature~~
This remix is much easier to print fast and easy! Remove supports and base, then hang with a swivel.
Note: This is pretty much max overhang allowed- I had to reduce speed as it got taller eventually down to 20% near the top. The slower the better quality. If you go too fast the model may bend and cause extruder crashes. After this…
During Covid-19 my son and I enjoyed designing and building various Tricopters. The Whirlygig was our attempt at making the smallest Tricopter possible for outdoor use. All up weight being just over 54 Grams and acrobatic flight time of…
how to build: you need a 3' 10" piece of string, feed both ends through the holes and tie the ends in a knot, creating a loop. to use: put a finger in the loop on each side of the disk. wind up the string by spinning the disk, then pull…
Uses 2- 6203 bearings, RS or ZZ both work. RS should be fine and cheaper. Printed in ABS with 0.6 nozzle, 6 walls and 25% infill. Bearings are press fit, the spool holder has a tapered internal section to help with printing without…
Just a simple pole adapter to allow connecting the .25inch (6.2mm) fiberglass rods that hold driveway reflectors to hold my Whirlygigs and pin Wheels. These rods are typically available from the big box home improvement stores for only a…
