18 modeli
Perfect for holding 4 makers with a diameter of up to 18mm. I used these magnets (6x2mm) Print instructions 0.2 Layerheight 15% infill Add pause after 12th layer (see attached .bgcode file) no supports needed
You can use this marker holder with magnets, so you always have your whiteboard markers where you need it. There are three holes für magnets with a diameter of 15 mm and a height of 2 mm. Just add a print pause after 29 mm, so you can…
EN: This is a wall mount bracket for dots office brand whiteboards. I changed the unfilled back as this was the weak point of the original mount. For good strength I recommend using PETG at 100% infill and placing the model on its side…
Whiteboard pen holder for white boards with the T slot around the outside of the board (as shown in one of the photographs). The pen holder slides into the T slot and can be positioned anywhere along the bottom of the board. Print…
Simple magnetic holders for the slim style (Expo or other brands with a similar style) dry erase pens. The magnet is inserted into the print with a print pause at the appropriate layer. Required Non-Printable Parts: 1x – 12.7 x 3.2mm disc…
Made left, middle and right part, and then can snap together with magnets as well as magnetic to a whiteboard. 23mm height, should fit multiple standard sticky notes blocks. The holes for the magnets fits with 2.5x6.0/6.5mm magnets.…
I used these https://www.amazon.com/dp/B09MM2TMC7 suction cups. Updated the model to only have 4 suction cup mounting points (original had 8 and they were too close together to use all 8). Also cleaned up some of the model so there…
With the environmental issues we are facing today, I felt guilty everytime I reach out for some paper to rough out a design sketch or to perform some calculations. As a result, I have now taken up mini whiteboards as my scratchpad. The…
There are three pico bonsai so far in the set, each needs three ⌀6mm by 3 thick cylindrical magnets. They could make a perfect gift for a teacher and are suitable for air plants : A rectangular bonsai: This pico bonsai pot, perfect for…
Magnetic penholder for whiteboards. in standard PLA settings. Dimension of the magnets 12x3mm Dimension of the magnet stripe: 15x1.5mm
Predstavujem svoj nový model - stojan na fixky, ideálny pre tvorcov a kreatívnych jedincov. Tento dizajn umožňuje usporiadať až 8 fixiek, čím vám poskytuje praktické a efektívne riešenie pre váš pracovný priestor alebo umeleckú dielňu.…
Summary The problem statement was to make a set of reusable hexagons for writing on in “hexagonal thinking” assignments. The final result is a collection of 5 sets of 7 hexagonal whiteboards for “Hexagonal Thinking,” each 8.3cm across and…
Shelf for the magnetic eraser for whiteboards, mountableto skadis
Here you can find two magnet housings (for 10mmX3mm and 5mmX1.5mm magnets) that can be used with witheboards
Magnetic Symbol Set for Whiteboards Create a manual filament change at 2.6 mm Add ø15x3 Magnets
This frame is designed to give whiteboards and similar panels a clean, finished appearance while adding a modern decorative touch. The frame consists of 6 individual parts , which are connected using 8 connecting pins . 📏 Dimensions:…
Shelf for the magnetic eraser for whiteboards, mountableto skadis
Perfect for holding 4 makers with a diameter of up to 18mm. I used these magnets (6x2mm) Print instructions 0.2 Layerheight 15% infill Add pause after 12th layer (see attached .bgcode file) no supports needed
